New Torch, nothing fits!
I got myself a Bravo and when I sit in front of it.. it is too tall compared to my lynx! Which means I need a new chair? I don't think a standard office chair that raises will work anymore, as I had it on the highest lift. And if I did... then my elbows won't rest on the creation station anymore!
It's a dumb question but.... has anyone else upgraded and needed to literally "up" grade? What did you do? i see that Dustin Revere has a slide out thing for his torch under the bench.. that may be the answer, does anyone know where to get something like that? |
Can you elevate yourself with a seat pillow?
|
Actually, I installed 2 x 4 between the frame of my chair and the bottom of the seat.
I had to hunt up longer screws from the hardware store. I also keep handy a half dozen fabric faced foam "yoga" blocks that I can stack, rotate or stand on end for elbow rests while I'm torching. I cut a hole in the bench top to run my hoses through because I didn't like it so close to the front edge that I didn't have any place to put my elbows. It was my way around having to make 'wings' like on a 'creation station'. ETA: Once I got high enough to be comfortable with the bench surface I found that my feet dangled so I have a 6 by 6 about 4 feet long to put my feet on. |
Since the torch was the only thing that changed, maybe try "lowering" the torch. That might be an easier job than raising everything else up higher.
|
All times are GMT -7. The time now is 6:13am. |
Powered by vBulletin® Version 3.7.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.