FtL error message kiln
my paragon kiln has given me an FtL / fired too long message. It was not getting up to heat. I think this happened once before and I reset the program but memory escapes me. Any suggestions?
|
ok, what to do if half the elements have stopped working?
|
What kind of kiln? I think if there are no troubleshooting tips for that, that I would contact the company.
I think most of them are pretty happy to help. |
Maybe ask the makers for advice? http://www.paragonweb.com/Kiln_Guru.cfm
It looks like they are very helpful. This thread http://www.lampworketc.com/forums/ar.../t-224738.html might be of interest - it discusses loose connections rather than failed elements. Hope you fix it easily, so frustrating when the kiln plays up! |
|
They are very, very helpful at Paragon. Susan was on the phone with me for an hour diagnosing an error message my kiln had.
|
got a call in, waiting for a call back...
|
need to get a multi tester to check if its a relay problem ... has anybody done this on a paragon?
|
Relays are so cheap I would just replace it and see if that works.
|
Aye and if that is not it then you will have a spare on hand in case it does go out later
|
sounds sensible.. :)
|
I did it a couple of years ago-Paragon walked me through the process. :)
|
All times are GMT -7. The time now is 4:26pm. |
Powered by vBulletin® Version 3.7.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.