coring beads
Hi everyone, I'm a newbie here :wave:
Sorry if I am posting this in the wrong place. I am trying to core beads with a Perlenpress bead liner, at first everything seemed to go fine and I thought I had got the hang of it, but now I find the core isn't flaring evenly, after a few turns the core goes like this \ which means when I try to tighten the core for a snug fit, one side of the core is too tight to the bead, so chips and cracks the bead, while the other side is 1 or 2 mm away from the surface of the bead. I have studied lots of tutorials on You Tube but they just make it look easy, I need to know what I am doing wrong ! Thanks |
Are you using a jig to cut your tube with a nice perpendicular edge?
|
the tube/core might be a smidge too long.....
|
I'm not familiar with that bead liner but how much extra length are you allowing on your tubing when you cut it?
|
All times are GMT -7. The time now is 3:41am. |
Powered by vBulletin® Version 3.7.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.