Thread: Studio 8 Even heat kiln
View Single Post
  #3  
Old 2016-12-18, 2:04am
Magma's Avatar
Magma Magma is offline
Senior Member
  
Join Date: Jun 11, 2008
Location: Brisbane, Australia
Posts: 1,010
Default
I have never used that kiln, but I can tell you my kiln cycle

I hold my beads at 515C until I finish work, then when I put my last bead of the day in I keep it at 515C for an extra hour, after that my kiln ramps down to 220C at I think it's around 150C an hour. Once it reaches 220C the kiln turns off and it takes a while for it to reach room temperature.

I'm sure everyone uses different cycles out there, this one has always worked for me.

All the best !
Régis
__________________

To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.


Magma Beads .
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
.
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
.
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
 .
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
.
Reply With Quote