Thread: Homemade tools
View Single Post
  #61  
Old 2012-03-15, 1:46pm
flaming_fools's Avatar
flaming_fools flaming_fools is offline
Dynamic Duo
 
Join Date: Aug 13, 2009
Location: Oakland, CA
Posts: 1,605
Default Rod Rests

In the paint section a the hardware store I noticed these gizmos for sitting over paint cans, or in roller pans, to run your brush or roller over to remove excess paint. They were real cheap. Just bought and bent in half to make a V. Have been planning to cut off the curved 'legs' on the end, but have not done so yet.

I like these as there are multi levels for sticking the rods, either on top, or through the holes. Very little contact point for chilling the rods.

__________________

To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.


To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
.
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
.
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
.
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
.
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
.
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
Reply With Quote