View Single Post
  #19  
Old 2010-12-20, 3:19pm
Cosmo's Avatar
Cosmo Cosmo is offline
ManBearPig
 
Join Date: Jun 28, 2005
Location: Roanoke, VA
Posts: 8,540
Default

I like the concept, but I have to ask...

How much is it going to cost? And how much work will go into it, especially if it isn't perfect the first time?

I've seen used lathes as cheap as $1500. Not knocking your creative impulses, but I'm afraid you may be getting to the point where it would be cheaper just to buy one...
__________________

To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.


To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.

To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.

To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.

To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
Reply With Quote