Thread: kipn problems
View Single Post
  #1  
Old 2020-05-29, 7:44pm
Jebson710 Jebson710 is offline
Junior Member
 
Join Date: May 29, 2020
Posts: 13
Default kipn problems

I'm quite the noob to glass blowing and have never owned a kiln before. I recently bought a paragon f120 with a sentry xpress 5.0 controller. Its a 120v kipn yet ive been hving nothing but problems, ive finally managed to get it to run up to the desired temp but now after about an hour or so it'll go over the alloted temp and then shut off. I don't know much about electricity type stuff and was hoping anyone might now the cause of this. Thank you so much for your help!
Reply With Quote