They are very simple to do. Basically heat the rod and condense or pull it out to whatever design you like. Then put it in the kiln.
If you have a lathe they are pretty much hands-free. If not, invest in a good set of rollers before you attempt it. Two sets would be even better. I've done them without rollers and it's not fun.
__________________
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts. • To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts. • To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts. • To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
|