Even though the black enamel ones say that they are low fuse in order to get a good glossy surface on the enamel you have to do one more step. After bringing those up to full fuse temp and they have soaked for the required amount of time start ramping your kiln down to around 1000 degrees.
At this point take your bead out of the kiln and finish fusing the decal in the back of the flame. You will see the decal turn black and glossy. If you try to do this just by soaking them at temp in your kiln you will slump your bead.
__________________
Mary Beth
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
|