First cut the decal out that you want to use. Soak it in warm water until it slides freely a min or so. Slide the decal off the paper onto your glass. Then squeegee it with a wet cloth or wet paper if you don't have a rubber one. Let it sit for a while to dry. Load it into your kiln leaving it ventilated until all residue is burnt off. Don't breath the fumes. Close the kiln up and run it up to Ceramic Cone #022 or 1050 Degrees. If the decals are under fired you will see a slight halo around them. These are glass enamels that have been silk screened on to a nitro glycerin film.
|