Paragon Caldera
Hi Tracy,
I have a Caldera which I use for annealing boro beads, marbles and pendents. The bead door is needed for easy access as you work.That's probably the biggest issue concerning this kiln, or any kiln not having a door. Aside from that, it's a nice kiln,easily programmed,and accurate temp-wise. I have done some fusing with it and found it was worth my getting the glass viewport top in order to check the fusing as it occurs. Sure, I'd like easier access that comes with a door and the ability to work larger (taller)pieces at some point as the bead door makes it difficult to work in and out of the kiln if working a piece in stages. But that is also restricted by my torch size (lynx) and for the near future,my work won't be getting too big.So embrace the caldera until it holds you back.
Just my opinion, hope it helps.
Kevin
|