using the rivit tool to get the stuck beads off was part of my first post. i also talked about the use of an ultrasonic cleaner to help remove the bead release. has anyone tried this idea?
you need an ultrasonic cleaner that can be run for a relatively long time, some cheaper ones only allow you to clean for a minute or less. also the solution is important. i have always used windshield cleaning solution, but if you have beads with exposed reduction finishes on the outside, you may wish to use an ammonia solution.
you may still need to brush the bead hole a little, but the whole process of cleaning will go way easier.
__________________
Mark Wilson
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
|