View Single Post
  #4  
Old 2018-05-06, 10:47am
jlborek jlborek is offline
Jenn @ Kanna Glass Studio
 
Join Date: May 11, 2017
Location: St. Augustine, FL
Posts: 8
Default

Thank you Alaska and Speed Slug! I reorganized my production plan this week to work on the silver charms with polymer clay components, so I'm just going to sit back, bite my nails that my OxyCon is fixable and get going when I get it back.

Thank you for the suggestions on the chaining the OxyCons together. I think one of my future plans is to have two OxyCons so I can have a back-up and possibly work bigger if I need to, although I tend to focus on tiny beads.

I have plumbed in propane at 5 PSI. Given that my poor OxyCon was producing so little oxygen, I was suspecting even a 5-7 PSI OxyCon would be sufficient. After watching some of the warning videos about the tanks, I got a little anxiety with using those, but I'm keeping it in the back of my mind.
Reply With Quote