Except for the controller of the kiln I built myself back 2007 or something I can not think of any kilns that have been troublesome at all.
My controller was one of those that the manual was translated through 8 different languages before some one rewrote it in something kind of like english but that was my own fault for going cheap in my build. (Well, there wasn't much of a selection at the time either.)
I assume that the kind with the guillotine door could be annoying for bead makers because the door dumps the heat out every time it is opened but other than that I don't know of any that folks have complained about.
Perhaps I just have not noticed negative comments about kilns.
__________________
The Zombie Apocalypse is Upon Us.
|