I have all three systems ... plus I used to hand dap as well. This is what I currently do ...
1. press in the Jim Moore until it's reasonably flared ... use the plastic thingeys to press it further. Quickest easiest to get the job done.
2. Pop in into the Impress to get the flat look (my preference) ...
3. Hand dap if there's still some room between the bead and metal. Using doming block, or bench block (depending on final look) and hammer (gentle touch).
__________________
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
|