Quote:
Originally Posted by jaci
I ran a line from the tank inside and then attached the regulator, and then had it go to the hose to the torch. I had to bring the regulator to the welding supply shop so they could put in a different fitting on the end of the regulator to fit the hose.
If you bleed the line there should be no need to shut off the regulator, and it will save you time finding the right spot when you turn it on, unless you are disconnecting your tank, (which will reset the regulator anyways)
|
I was told that this was not a good idea, due to the pressure in the hose coming directly from the tank. (Since the pressure would be equal to the pressure in the tank, I.e. HIGH). Is there a special type of hose or pipe that used to do this? Is length limited?
Thanks again for everyone's help