But iof they are only 1/2 inch long.....i don't know if that would work, a normal push pin(the metal part that sticks out from the plasitc) is about 3/8 of an inch. so if the victorla needle is less than that i don't think the pish pin would stay in the wall/board. I would have to be at least 1/2 an inch....or more so you could either make your glass on it OR glue in afterwards.....
how can we figure out how long they are? and how thick?
__________________
"You create your own reality"
*StOrM*
Nortel Minor- Natural gas & Oxycon
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
|