View Single Post
  #4  
Old 2019-05-23, 2:03pm
beadmama's Avatar
beadmama beadmama is offline
Senior Member
 
Join Date: Sep 22, 2006
Posts: 1,130
Default

Good and bad in both ....brass Will tarnish. I do think the graphite can chip easily on the corners. I had 2 that chipped in the corner near the peg hole. I didnít drop it either. The press is usable but if brass is offered I would go that route instead. I do like graphite beadrollers and had a couple spacer ones break from dropping them. JMHO
__________________
Becky
Reply With Quote