New Torch, nothing fits!

[lunesse]

I got myself a Bravo and when I sit in front of it.. it is too tall compared to my lynx! Which means I need a new chair? I don't think a standard office chair that raises will work anymore, as I had it on the highest lift. And if I did... then my elbows won't rest on the creation station anymore!

It's a dumb question but.... has anyone else upgraded and needed to literally "up" grade? What did you do?

i see that Dustin Revere has a slide out thing for his torch under the bench.. that may be the answer, does anyone know where to get something like that?

[echeveria]

Can you elevate yourself with a seat pillow?

[Speedslug]

Actually, I installed 2 x 4 between the frame of my chair and the bottom of the seat.
I had to hunt up longer screws from the hardware store.

I also keep handy a half dozen fabric faced foam "yoga" blocks that I can stack, rotate or stand on end for elbow rests while I'm torching.

I cut a hole in the bench top to run my hoses through because I didn't like it so close to the front edge that I didn't have any place to put my elbows.
It was my way around having to make 'wings' like on a 'creation station'.

ETA: Once I got high enough to be comfortable with the bench surface I found that my feet dangled so I have a 6 by 6 about 4 feet long to put my feet on.

[rcktscientist]

Since the torch was the only thing that changed, maybe try "lowering" the torch. That might be an easier job than raising everything else up higher.