Check under knob, is there a "hex nut" that valve shaft goes through....
IF so its probably loose, take a "open end wrench" the correct size and gently tighten this nut... If you get it to tight knob will be difficult to turn, to loose and it can leaks fuel around shaft.... Always check for leaks after working on torch valves.
Dale
__________________
You can lead a person to knowledge, but you can't make them think.
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
Vendor-Artist-Studio-Teacher Registry
To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
San Francisco - A Few Toys Short of a Happy Meal
|
Tighten torch knobs?
